Characteristic | Description |
|---|
Channels | 1 |
Waveforms | Sine, Square, Pulse, Ramp, Noise, DC, Sin(x)/x, Gaussian, Lorentz, Exponential Rise, Exponential Decay, and Haversine |
Sine Wave | 1 μHz to 20 MHz |
Sine Wave in Burst Mode | 1 μHz to 10 MHz |
Effective Maximum Frequency Out | 20 MHz |
Amplitude Flatness (1 Vp-p) |
<5 MHz | ±0.15 dB |
5 MHz to 20 MHz | ±0.3 dB |
Harmonic Distortion (1 Vp-p) |
10 Hz to 20 kHz | <–70 dBc |
20 kHz to 1 MHz | <–60 dBc |
1 MHz to 10 MHz | <–50 dBc |
10 MHz to 20 MHz | <–40 dBc |
THD | <0.2% (10 Hz to 20 kHz, 1 Vp-p) |
Spurious (1 Vp-p) |
10 Hz to 1 MHz | <–60 dBc |
1 MHz to 20 MHz | <–50 dBc |
Phase Noise, Typical | 20 MHz: <–110 dBc/Hz at 10 kHz offset, 1 Vp-p |
Residual Clock Noise | –63 dBm |
Square Wave | 1 μHz to 10 MHz |
Rise/Fall Time | ≤18 ns |
Jitter (RMS), Typical | <500 ps |
Ramp Wave | 1 μHz to 200 kHz |
Linearity | ≤0.1% of peak output at 10% to 90% of amplitude range |
Symmetry | 0.0% to 100.0% |
Pulse Wave | 1 mHz to 10 MHz |
Pulse Width | 30.00 ns to 999.99 s |
Resolution | 10 ps or 5 digits |
Pulse Duty | 0.001% to 99.999% (Limitations of pulse duty width apply) |
Edge Transition Time | 18 ns to 0.625 × Pulse Period |
Resolution | 10 ps or 4 digits |
Lead Delay |
Range | Continuous Mode: 0 ps to Period Trigger/Gate Burst Mode: 0 ps to Period – [Pulse Width + 0.8 × (Leading Edge Time + Trailing Edge Time)] |
Resolution | 10 ps or 8 digits |
Overshoot, Typical | <5% |
Jitter (RMS), Typical | <500 ps |
Other Waveforms | 1 μHz to 200 kHz |
Noise Bandwidth (–3 dB) | 20 MHz |
Noise Type | White Gaussian |
DC (into 50 Ω) | –5 V to +5 V |
Arbitrary Waveforms | 1 mHz to 10 MHz |
Arbitrary Waveforms in Burst Mode | 1 mHz to 5 MHz |
Effective Analog Bandwidth (–3 dB) | 34 MHz |
Nonvolatile Memory | 4 waveforms |
Memory: Sample Rate | 2 to 128k: 250 MS/s |
Vertical Resolution | 14 bits |
Rise/Fall Time | ≤20 ns |
Jitter (RMS) | 4 ns |
Amplitude, 50 Ω Load | 10 mVp-p to 10 Vp-p |
Amplitude, Open Circuit | 20 mVp-p to 20 Vp-p |
Accuracy | ±(1% of setting + 1 mV), (1 kHz sine waveform, 0 V offset, >10 mVp-p amplitude) |
Resolution | 0.1 mVp-p, 0.1 mVRMS, 1 mV, 0.1 dBm, or 4 digits |
Units | Vp-p, VRMS, dBm (sine wave only) |
Output Impedance | 50 Ω |
Load Impedance Setting | Selectable: 50 Ω, 1 Ω to 10.0 kΩ, High Z (adjusts displayed amplitude according to selected load impedance) |
Isolation | <42 VPeak maximum to earth |
Short-circuit Protection | Signal outputs are robust against permanent shorts against floating ground |
External Voltage Protection | To protect signal outputs against external voltages use fuse adapter 013-0345-00 |
DC Offset Range, 50 Ω Load | ±(5 VPeak – amplitude Vp-p/2) |
DC Offset Range, Open Circuit | ±(10 VPeak – amplitude Vp-p/2) |
Accuracy | ±(1% of |setting| + 5 mV + 0.5% of amplitude (Vp-p)) |
Resolution | 1 mV |
