Electrical Specifications
	Output Ratings:
	Output voltage		0 - 18 V
	Output current		0 - 10 A
	Outputs		1
	Output power		180 W
	Operating mode		Constant voltage or constant current with automatic cross-over and indication
	Voltage setting		By coarse and fine controls
	Current setting		By single logarithmic control
	Output impedance		Typically <5mW in constant voltage mode. Typically >10kW in constant current mode.
	Line regulation		<0.01% of max. output for a 10% line voltage change
	Load regulation		<0.01% of max. output for a 90% load change
	Ripple and noise (20 MHz bandwidth)		Typically <2 mV rms, <10 mV pk-pk
	Transient response		<200ms to within 50 mV of set level for 90% load change
	Temperature coefficient		Typically <100ppm/oC
	Output protection		Outputs will withstand forward voltages up to 40 V
	Status indication		Output ON lamps. Constant current mode lamps.
	Output switch		Electronic. Preset voltage/current displayed with output off.
	Output terminals		4mm terminals on 19mm (0.75") pitch. Special safety terminals on XPH 75-2D.
	Meters (main outputs):
	Meter types		Separate 3 digit meters for voltage and current with 14mm (0.56") LED displays. Reading rate 4/sec (4 digit voltmeter on XPH 75-2D).
	Meter resolution		100 mV, 10 mA
	Meter accuracy:
	Voltage		0.3% +/- 1 digit
	Current		0.6% +/- 1 digit
	XPH 18-10 Model
	Output protection		As XPH series but with a limit of 22 V.
	Remote selection		Switch selectable as Local or Remote
	Connection		Remote sense connections via spring loaded connectors
	Meter types		Separate 4 digit meters for voltage and current with 14mm (0.56") LED displays. Reading rate 4/sec.
	Meter resolution		10 mV, 10 mA
	Meter accuracies		Voltage 0.3% +/- 1 digit. Current 0.6% +/- 1 digit.
	General Specifications
	Cooling		Convection (Fan assisted for XPH 42-10)
	Output terminals:
	Standard type		4mm "binding post" terminals suitable for plugs or wires
	Optional (all models)		4mm safety sockets, suitable for shrouded plugs
	AC input		Factory set: 110 to 120 VAC +/- 10% or 220 - 240 VAC +/- 10%, 50/60 Hz Installation Category ll
	Consumption		400 VA
	Operating range		5oC to 40oC, 20% to 80% RH
	Storage range		-40oC to 70oC
	Environmental		Indoor use at altitudes to 2000m, Pollution Degree 2
	Safety		Complies with EN61010-1
	EMC		Complies with EN61326
	Dimensions (HxWxD)		160 x 140 x 320mm
	Unit weight		6.2 lbs/2.8 kg
	Warranty		3 years
	Regulatory Approvals
	CE-marked units meet: EN61010-1 and EN 61326
Note: Specifications subject to change without notice.