Caracteristicas
P6245 Active Probes for TEKPROBE BNC Interfaces
The P6245 Active FET probe is the high performance probing solution for 500 MHz oscilloscopes. The P6245 has a probe only bandwidth of 1.5 GHz and will provide a 500 MHz system bandwidth when used with Tektronix' full line of 500 MHz oscilloscopes. In addition, the P6243 is powered by the TEKPROBE BNC interface, eliminating the need for additional power supplies and cables when used with TEKPROBE BNC oscilloscopes.
The P6245 offers superior signal acquisition on surface mount devices compared to the much higher capacitive loading of passive probes. The P6245 has less than or equal to 1 pF capacitive loading which allows it to measure high speed signals without affecting the signal or device under test. Furthermore, the included accessories and adapters allow for easy attachment to SMDs.
Active FET probe achieves high-speed signal acquisition by solving three traditional problems:
- Lower DUT loading (Less than or equal to pF/1 M ohm¸ probe loading)
- Direct and easy access to SMDs
- Access DUT signals and scope bandwidth for TDS600/700/3000/5000/6000/7000*1 and CSA7000 scopes up to 1 GHz bandwidths
The P6245 Active probes provide the electrical and mechanical performance required for today's digital systems designs. No additional power supplies or cables are required when used with TEKPROBE BNC oscilloscopes. Both the P6245 and P6243 achieve high-speed signal acquisition and low circuit loading, required for solving today's problems faced by designers.
The small compact probe head and versatile attachment accessories allow direct connection to the device under test.
The P6245 and P6243 Active Probes provide scope bandwidth at the probe tip for the TDS500/600/700; the P6243 provides scope bandwidth at the probe tip for the TDS3000 Series scope up to 1 GHz bandwidth.
1* Some TDS6000 or TDS7000 oscilloscopes require a TCA-BNC adapter.
|
Calibración
